Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Staple-less construction
By:rnb4tla
Date: 12/11/2004, 2:51 pm
In Response To: Re: Strip: Staple-less construction (Randy Ricchi)

Rob Mack's stripping designs provide for a gap between the hull & deck once both sides are tripped (while still attached to stations). You then use a long flat bar to slide between the hull/deck to separate them. You still gotta be careful.

If your strip design (and stations) don't allow for this you might have problems.

Messages In This Thread

Strip: Staple-less construction
Randy Ricchi -- 12/10/2004, 9:26 am
Re: Strip: Staple-less construction *LINK*
Tony Olsen -- 12/10/2004, 10:50 pm
Re: Strip: Staple-less construction
Roger Turgeon -- 12/10/2004, 5:56 pm
correction no duct tape!
Rob B -- 12/10/2004, 7:35 pm
Re: Strip: Staple-less construction
Kyle T -- 12/10/2004, 3:26 pm
Re: Strip: Staple-less construction
Rob B -- 12/10/2004, 10:26 am
Re: Strip: Staple-less construction
Randy Ricchi -- 12/10/2004, 10:36 am
Re: Strip: Staple-less construction
rnb4tla -- 12/11/2004, 2:51 pm
Re: Strip: Staple-less construction
Will -- 12/11/2004, 10:05 pm
hot glue tests
Rob B -- 12/12/2004, 12:40 am
Re: Strip: Staple-less construction
Gennie -- 12/10/2004, 11:33 am
Re: Strip: Staple-less construction
Randy Ricchi -- 12/10/2004, 12:16 pm
Mine snapped right off...
Jesper Bach -- 12/10/2004, 1:45 pm
Re: Mine snapped right off...
Rob B -- 12/10/2004, 2:00 pm