Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Seeking: Strip building tools
By:Bill Hamm
Date: 8/31/2007, 1:06 am
In Response To: Re: Seeking: Strip building tools (Aaron)

: I think everyone that builds these boats uses their own modified tools.
: nobody goes by the book anymore. The book I read suggested using a pocket
: knife to make skarfs and such. I use a table saw. I stopped using my
: planer because it got a little dull and gouged into my deck. Now I use a
: belt sander. and finish with an orbital. never even seen a fairing board.
: If I were you I would just start building and buy tools as I need them.
: That way you wont waste too much money on tools youll never use.
: (spokeshave)

I've only used my spokeshaves for paddles.

Bill H.

Messages In This Thread

Seeking: Strip building tools
Kyle H. -- 8/30/2007, 12:40 pm
Re: Seeking: Strip building tools
John Eberly -- 8/31/2007, 11:57 am
Re: Seeking: Strip building tools
Kyle H. -- 9/2/2007, 5:54 pm
Re: Seeking: Strip building tools
Bill Hamm -- 9/3/2007, 1:11 am
Re: Seeking: Strip building tools
Acors -- 8/31/2007, 9:52 am
Re: Seeking: Strip building tools
TOM RAYMOND -- 9/5/2007, 3:05 pm
Re: Seeking: Strip building tools
Acors -- 9/6/2007, 12:21 pm
Re: Seeking: Strip building tools
Carl H -- 8/30/2007, 5:35 pm
Re: Seeking: Strip building tools
Mike Savage -- 8/30/2007, 5:49 pm
Re: Seeking: Strip building tools
Aaron -- 8/30/2007, 6:33 pm
Re: Seeking: Strip building tools
Bill Hamm -- 8/31/2007, 1:06 am
Re: Seeking: Strip building tools
Justin L -- 8/30/2007, 4:53 pm
Re: Seeking: Strip building tools
John Monroe -- 9/1/2007, 4:55 am
Re: Seeking: Strip building tools
Bill Hamm -- 8/30/2007, 6:18 pm
Re: Seeking: Strip building tools *Pic*
Justin L -- 8/30/2007, 8:44 pm
Re: Seeking: Strip building tools
Bill Hamm -- 8/31/2007, 1:05 am
Re: Seeking: Strip building tools
Phil -- 8/31/2007, 6:11 am
Re: Seeking: Strip building tools
Bill Hamm -- 8/31/2007, 10:47 am
Re: Seeking: Strip building tools
Justin L -- 8/30/2007, 4:56 pm