Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Paddle: Tip Protection
By:Pawistik
Date: 9/10/2007, 1:44 am
In Response To: Re: Paddle: Tip Protection *LINK* (jeffrey)

: 3. Cut a slot & insert a hard material(Requires a jig & table saw)

A table saw, though likely the better option, is not the only way. I have cut the slot using a hand saw. A tiricky cut to be sure, but not impossible. It was done before the paddle had been shaped so it was still pretty square on the end.

Cheers,
Bryan

Messages In This Thread

Re: Paddle: Tip Protection *LINK*
jeffrey -- 9/8/2007, 9:42 pm
Re: Paddle: Tip Protection *Pic*
Dave Houser -- 9/10/2007, 10:09 pm
Re: Paddle: Tip Protection
jeffrey -- 9/11/2007, 12:46 am
Re: Paddle: Tip Protection *Pic*
Dave Houser -- 9/11/2007, 1:16 am
Re: Paddle: Tip Protection
Pawistik -- 9/10/2007, 1:44 am
Re: Paddle: Tip Protection
Bill Hamm -- 9/12/2007, 4:45 am
Re: Paddle: Tip Protection *LINK* *Pic*
pawistik -- 9/12/2007, 4:42 pm
Re: Paddle: Tip Protection
Bill Hamm -- 9/16/2007, 3:56 am
Re: Paddle: Tip Protection
Scott Baxter -- 9/9/2007, 9:40 am
Re: Paddle: Tip Protection
Bill Hamm -- 9/9/2007, 1:55 am