Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Strip Ripping Woes, Advice Requested
By:Dan Price
Date: 9/13/2007, 4:05 pm
In Response To: Re: Strip: Strip Ripping Woes, Advice Requested (Bill Hamm)

Hey, Bill. I started with the 10" Ryobi all purpose, changed to a Freud Diablo 7.25" thin kerf, and ended up with a DeWalt 8" multi-purpose thin kerf. All blades pretty much produced the same quality of cut, but the smaller ones resulted in zero bog down when cutting ash. I went to the 8" because I'm using a piece of 3/4" plywood bolted to the top of the table, and I didn't have enough blade protrusion to cut 3/4" stock with the 7.25".

Dan

: What are you using for a saw blade?

: Bill H.

Messages In This Thread

Strip: Strip Ripping Woes, Advice Requested
Dan Price -- 8/27/2007, 9:10 am
Re: Strip: Strip Ripping Woes, Advice Requested
Dan Price -- 9/13/2007, 9:13 am
Re: Strip: Strip Ripping Woes, Advice Requested
Bill Hamm -- 9/13/2007, 2:02 pm
Re: Strip: Strip Ripping Woes, Advice Requested
Dan Price -- 9/13/2007, 4:05 pm
Re: Strip: Strip Ripping Woes, Advice Requested
Bill Hamm -- 9/16/2007, 3:07 am
Re: Strip: Strip Ripping Woes, Advice Requested
John Eberly -- 9/17/2007, 11:37 am
Re: Strip: Strip Ripping Woes, Advice Requested
Bill Hamm -- 9/18/2007, 1:52 am
Re: Strip: Strip Ripping Woes, Advice Requested
Bill Hamm -- 9/16/2007, 3:01 am
Re: Strip: Strip Ripping Woes, Advice Requested
Bill Hamm -- 8/28/2007, 6:55 pm
Re: Strip: Strip Ripping Woes, Advice Requested
Carl H -- 8/28/2007, 6:26 pm
Re: Strip: Strip Ripping Woes, Advice Requested
Greg Clopton -- 8/28/2007, 10:46 am
Re: Strip: Ripping advice
Rehd -- 8/28/2007, 2:38 am
Pulling wood
Jay Babina -- 8/27/2007, 12:38 pm
Re: Pulling wood
Rob Macks / Laughing Loon -- 8/27/2007, 1:11 pm
Re: Strip: Strip Ripping Woes, Advice Requested
Rob Macks / Laughing Loon -- 8/27/2007, 11:53 am
Re: Strip: Strip Ripping Woes, Advice Requested
Acors -- 8/27/2007, 10:03 am
Re: Strip: Strip Ripping Woes, Advice Requested
TOM RAYMOND -- 8/27/2007, 9:36 am