Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Rolling Bevel Strips *Pic*
By:John Monroe
Date: 9/28/2007, 4:27 am
In Response To: Strip: Rolling Bevel Strips (Shaun Hamilton)

This worked out well for me. I set the strip in the jig pictured and planed about a 10-degree angle on only one side. This angle worked for 3/4 of the strips used on the boats. I plane two other angles also by slipping a thin strip under the strip I was planning to give a more acute angle, and then even more my setting an extra loose fence next to the fixed fence.

John

Messages In This Thread

Strip: Rolling Bevel Strips
Shaun Hamilton -- 9/26/2007, 4:34 pm
Re: Strip: But Why???
Carl H -- 9/28/2007, 6:13 pm
Re: Strip: But Why???
PGJ -- 10/1/2007, 2:06 pm
Re: Strip: But Why???
Bill Hamm -- 10/2/2007, 4:30 am
As Sir Isaac said . . .
Paul G. Jacobson -- 10/2/2007, 12:41 pm
Re: Strip: But Why???
Jay Babina -- 9/29/2007, 11:48 pm
Re: Strip: But Why???
Carl H -- 10/1/2007, 8:35 pm
Re: Strip: But Why???
Bill Hamm -- 10/2/2007, 4:27 am
Re: Strip: But Why???
TOM RAYMOND -- 10/1/2007, 1:28 pm
Re: Strip: But Why???
John Monroe -- 9/29/2007, 3:50 am
Re: Strip: But Why???
Bill Hamm -- 9/28/2007, 6:23 pm
Re: Strip: Rolling Bevel Strips *Pic*
John Monroe -- 9/28/2007, 4:27 am
Re: Strip: Rolling Bevel Strips
Mike Savage -- 9/28/2007, 5:27 pm
Re: Strip: Rolling Bevel Strips
John Monroe -- 9/29/2007, 3:55 am
Re: Strip: Rolling Bevel Strips
Mike Savage -- 9/29/2007, 4:41 am
Re: Strip: Rolling Bevel Strips
John Monroe -- 9/29/2007, 5:04 am
Re: Strip: Rolling Bevel Strips
Bill Hamm -- 9/29/2007, 3:53 pm
Re: Strip: Rolling Bevel Strips
John Monroe -- 9/30/2007, 4:33 am
Re: Strip: Rolling Bevel Strips
Bill Hamm -- 10/1/2007, 2:23 am
Re: Strip: Rolling Bevel Strips
Mike Savage -- 9/29/2007, 5:14 am
Re: Strip: Rolling Bevel Strips
Paul G. Jacobson -- 9/27/2007, 9:44 pm
Re: Strip: Rolling Bevel Strips
Rob Macks / Laughing Loon -- 9/27/2007, 10:13 am
Re: Strip: Rolling Bevel Strips
Bill Hamm -- 9/27/2007, 8:21 pm
Re: Strip: Rolling Bevel Strips
Bill Hamm -- 9/27/2007, 4:15 am
Re: Strip: Rolling Bevel Strips
Dave -- 9/26/2007, 4:57 pm