Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Rolling Bevel Strips
By:Bill Hamm
Date: 10/1/2007, 2:23 am
In Response To: Re: Strip: Rolling Bevel Strips (John Monroe)

: I didn't know that Bill. When I was working with blue foam board I used red
: but I don't see red very well. Yellow would have been much better for me.

: John

The hardware stores that the local contractors buy from usually will have it.

Bill H.

Messages In This Thread

Strip: Rolling Bevel Strips
Shaun Hamilton -- 9/26/2007, 4:34 pm
Re: Strip: But Why???
Carl H -- 9/28/2007, 6:13 pm
Re: Strip: But Why???
PGJ -- 10/1/2007, 2:06 pm
Re: Strip: But Why???
Bill Hamm -- 10/2/2007, 4:30 am
As Sir Isaac said . . .
Paul G. Jacobson -- 10/2/2007, 12:41 pm
Re: Strip: But Why???
Jay Babina -- 9/29/2007, 11:48 pm
Re: Strip: But Why???
Carl H -- 10/1/2007, 8:35 pm
Re: Strip: But Why???
Bill Hamm -- 10/2/2007, 4:27 am
Re: Strip: But Why???
TOM RAYMOND -- 10/1/2007, 1:28 pm
Re: Strip: But Why???
John Monroe -- 9/29/2007, 3:50 am
Re: Strip: But Why???
Bill Hamm -- 9/28/2007, 6:23 pm
Re: Strip: Rolling Bevel Strips *Pic*
John Monroe -- 9/28/2007, 4:27 am
Re: Strip: Rolling Bevel Strips
Mike Savage -- 9/28/2007, 5:27 pm
Re: Strip: Rolling Bevel Strips
John Monroe -- 9/29/2007, 3:55 am
Re: Strip: Rolling Bevel Strips
Mike Savage -- 9/29/2007, 4:41 am
Re: Strip: Rolling Bevel Strips
John Monroe -- 9/29/2007, 5:04 am
Re: Strip: Rolling Bevel Strips
Bill Hamm -- 9/29/2007, 3:53 pm
Re: Strip: Rolling Bevel Strips
John Monroe -- 9/30/2007, 4:33 am
Re: Strip: Rolling Bevel Strips
Bill Hamm -- 10/1/2007, 2:23 am
Re: Strip: Rolling Bevel Strips
Mike Savage -- 9/29/2007, 5:14 am
Re: Strip: Rolling Bevel Strips
Paul G. Jacobson -- 9/27/2007, 9:44 pm
Re: Strip: Rolling Bevel Strips
Rob Macks / Laughing Loon -- 9/27/2007, 10:13 am
Re: Strip: Rolling Bevel Strips
Bill Hamm -- 9/27/2007, 8:21 pm
Re: Strip: Rolling Bevel Strips
Bill Hamm -- 9/27/2007, 4:15 am
Re: Strip: Rolling Bevel Strips
Dave -- 9/26/2007, 4:57 pm