Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Rolling bevel on rough strips
By:greg fojtik
Date: 10/13/2007, 8:37 am
In Response To: Strip: Rolling bevel on rough strips (Dave Stoup)

I built a boat using rolling bevel with scrap siding I got free from a remodeling job where I work. It was all rough-sawn on one side and was also polyurethaned on that side. This was not an issue at all. The more difficult part was in refining my technique to get a consistently tight fit.

Messages In This Thread

Strip: Rolling bevel on rough strips
Dave Stoup -- 10/12/2007, 11:51 am
Re: Strip: Rolling bevel on rough strips
Ken F -- 10/15/2007, 8:29 am
Re: Strip: Rolling bevel on rough strips
Bill Hamm -- 10/16/2007, 5:12 am
Thanks!!
Dave Stoup -- 10/13/2007, 1:57 pm
Re: Thanks!!
Paul G. Jacobson -- 10/13/2007, 8:12 pm
Re: Strip: Rolling bevel on rough strips
greg fojtik -- 10/13/2007, 8:37 am
Don't do anyting - your wood is OK
Jay Babina -- 10/12/2007, 3:25 pm
Re: Strip: Rolling bevel on rough strips
Pedro Almeida -- 10/12/2007, 2:28 pm
Re: Strip: Rolling bevel on rough strips
Mike Braun -- 10/12/2007, 9:18 pm
Re: Strip: Rolling bevel on rough strips
Paul G. Jacobson -- 10/12/2007, 12:51 pm
Re: Strip: Rolling bevel on rough strips
Rob Macks / Laughing Loon -- 10/13/2007, 12:53 pm
I have to disagree.
Pedro Almeida -- 10/14/2007, 1:37 pm
Half the story
Jay Babina -- 10/15/2007, 8:55 am
Re: Half the story
Pedro Almeida -- 10/15/2007, 11:54 pm
And now you know --the rest of the story
Paul G. Jacobson -- 10/18/2007, 1:26 am
We agree to disagree.
Rob Macks / Laughing Loon -- 10/14/2007, 10:05 pm
Re: We agree to disagree.
Pedro Almeida -- 10/15/2007, 11:18 pm
Re: I have to disagree.
Dan Caouette (CSFW) -- 10/14/2007, 3:21 pm
Re: I have to disagree.
Bryan Hansel -- 10/14/2007, 7:28 pm