Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: S&G: Plywood sources
By:Dave
Date: 10/30/2007, 9:31 pm
In Response To: S&G: Plywood sources (Kudzu)

Where do you live? Hmmm, kudzu grows in The South . . . but if you live in the PNW, I'd recommend Edensaw Lumber, in Port Townsend, WA.

As long as it's BS1088 Okoume, I daresay the brand shouldn't matter (?).

Good luck!

: Probably asked this before, but here goes.

: I have finally decided on the Diva Kayak. Hoping to start on two of them
: right after the holidays. I know of several places I can order plywood.
: There are none close by that I am aware of. But I wanted to know who you
: guys have used and about the service you got. Price is important but
: service and shipping is probably more so.

: Also, any recommendation on a particular brand of plywood? I would rather
: spend a little extra to get a good ply than cut corners!

Messages In This Thread

S&G: Plywood sources
Kudzu -- 10/30/2007, 6:56 pm
Re: S&G: Plywood sources
Joy -- 10/31/2007, 7:00 pm
Re: S&G: Plywood sources
Bill Hamm -- 11/1/2007, 1:22 am
Re: S&G: Plywood sources
TOM RAYMOND -- 11/1/2007, 12:31 pm
Re: S&G: Plywood sources
Bill Hamm -- 11/1/2007, 4:47 pm
Re: S&G: Plywood sources
Paul G. Jacobson -- 11/1/2007, 6:47 pm
Re: S&G: Plywood sources
Bill Hamm -- 11/2/2007, 10:36 am
Re: S&G: Plywood sources
Bill Hamm -- 10/31/2007, 1:26 am
Re: S&G: Plywood sources
Kudzu -- 10/31/2007, 5:54 pm
Re: S&G: Plywood sources
Paul G. Jacobson -- 10/31/2007, 8:17 pm
Re: S&G: Plywood sources
Bill Hamm -- 11/1/2007, 1:18 am
Re: S&G: Plywood shipping
Paul G. Jacobson -- 11/1/2007, 11:22 am
Re: S&G: Plywood shipping
TOM RAYMOND -- 11/1/2007, 12:01 pm
Re: S&G: Plywood sources
Mike Savage -- 11/1/2007, 8:05 am
Re: S&G: Plywood sources
Bill Hamm -- 11/1/2007, 4:45 pm
Re: S&G: Plywood sources
Dave -- 10/30/2007, 9:31 pm
Re: S&G: Plywood sources
Kudzu -- 10/30/2007, 11:03 pm
Re: S&G: Plywood sources
Brian Smith -- 10/31/2007, 9:10 am
Re: S&G: Plywood sources
george jung -- 10/30/2007, 11:27 pm