Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Wood Thickness *Pic*
By:Trey Decell
Date: 11/11/2007, 8:31 pm
In Response To: Re: Strip: Wood Thickness (J R Ackley)

Ok, Ok!! I won't build the boat out of the Mahogany, but I will use some of it for accent strips, I just thought it would make a beautiful boat. I was just not sure how heavy it would be. I'm attaching a pic of one plank and a smaller board that was dragged up from under the shop. (you can see the shop in the background, the front porch and entire floor is mahogany, covered in ply inside)

Messages In This Thread

Strip: Wood Thickness
Trey Decell -- 11/9/2007, 4:54 pm
Re: Strip: Wood Thickness
Bill Hamm -- 11/19/2007, 1:41 am
Mahogany boats...
Dan Caouette (CSFW) -- 11/12/2007, 8:48 am
Re: Mahogany boats...
Trey Decell -- 11/12/2007, 12:42 pm
Re: Mahogany boats...
Dan Caouette (CSFW) -- 11/12/2007, 3:02 pm
Re: Strip: Wood Thickness
J R Ackley -- 11/11/2007, 10:31 am
Re: Strip: Wood Thickness *Pic*
Trey Decell -- 11/11/2007, 8:31 pm
Re: Strip: Wood Thickness
Paul G. Jacobson -- 11/11/2007, 10:39 pm
Re: Strip: Wood Thickness
Trey Decell -- 11/11/2007, 11:50 pm
Re: Strip: Wood Thickness
PatrickC -- 11/11/2007, 12:39 am
You either have a fortune, or a typo !
Paul G. Jacobson -- 11/9/2007, 6:41 pm
Re: You either have a fortune, or a typo !
Trey Decell -- 11/9/2007, 6:51 pm
Re: You either have a fortune, or a typo !
Paul G. Jacobson -- 11/9/2007, 7:08 pm
Re: You either have a fortune, or a typo !
Trey Decell -- 11/9/2007, 7:12 pm
Re: You either have a fortune, or a typo !
Bryan Hansel -- 11/10/2007, 7:06 pm
Don't waste it
kent LeBoutillier -- 11/10/2007, 11:05 am
Re: Don't waste it
Mike Braun -- 11/10/2007, 1:51 pm
You won't believe this. *Pic*
John Monroe -- 11/12/2007, 5:25 am
Re: Don't waste it
Rob Macks / Laughing Loon -- 11/10/2007, 4:24 pm
Re: Don't waste it
Mike Savage -- 11/10/2007, 5:56 pm
Re: Don't waste it
Kurt Maurer -- 11/10/2007, 6:47 pm
Heavy boat
Jay Babina -- 11/11/2007, 9:34 am