Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Strip: Building a Strongback
By:CH10
Date: 12/22/2007, 8:03 am

As i have deemed my 2x4 too warped to use i was looking for some advice on building one out of plywood. i would like to know if it is a requirement to use a router on the edges to allow them to fit together??

Messages In This Thread

Strip: Building a Strongback
CH10 -- 12/22/2007, 8:03 am
Taking Advantage of Manufactured Edges on Plywood
Lloyd Peterson -- 12/27/2007, 2:55 am
Re: Taking Advantage of Manufactured Edges on Plyw
Paul G. Jacobson -- 12/30/2007, 8:14 pm
Re: Taking Advantage of Manufactured Edges on Plyw
Mike Scarborough -- 12/27/2007, 10:23 am
Thank You MIke
Lloyd Peterson -- 12/27/2007, 10:54 am
Re: Thank You MIke
Kudzu -- 12/27/2007, 12:13 pm
Re: Thank You MIke
Mike Savage -- 12/28/2007, 3:28 pm
Re: Thank You MIke *LINK* *Pic*
Etienne Muller -- 1/25/2008, 12:20 pm
Re: Thank You MIke
Etienne Muller -- 1/27/2008, 6:20 pm
Re: Thank You MIke
Roy Morford -- 12/27/2007, 1:10 pm
Re: Strip: Building a Strongback *Pic*
John Monroe -- 12/23/2007, 5:28 am
Correction--2 sheets of plywood *NM*
John Monroe -- 12/23/2007, 6:58 am
Re: Correction--2 sheets of plywood
Bill Hamm -- 12/24/2007, 1:31 am
Re: Correction--2 sheets of plywood
John Monroe -- 12/24/2007, 4:12 am
Re: Correction--2 sheets of plywood
Bill Hamm -- 12/24/2007, 4:16 am
Re: Strip: Building a Strongback
John Eberly -- 12/22/2007, 12:46 pm
Re: Strip: Building a Strongback
Kudzu -- 12/22/2007, 10:52 am
Re: Strip: Building a Strongback
Erik -- 12/22/2007, 11:44 am