Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Thanks! *Pic*
By:Dave Houser
Date: 1/9/2008, 12:10 am
In Response To: Re: Thanks! (Renee)

I use the Scotchbrite pads wet. A little ammonia or a squirt of kitchen detergent in a bucket of water to dip the pad in while scrubbing the epoxy will remove any blush (if it exists) and dirt (from the pool). Rinse with a garden hose and let dry well before rollering epoxy.

I like the yellow Tiz Twin Paks Rollers by Wooster, CLC and Glen-L sell them. Tip with a wood handled foam brush. Do not roll or tip after the epoxy kicks. Throw out epoxy that kicks in the tray, do not try to use it. It will shread your roller and brush and goober on too thick.

Messages In This Thread

S&G: uh oh! fill coat trouble??
Renee -- 1/8/2008, 11:22 am
Re: S&G: uh oh! fill coat trouble??
Mike Scarborough -- 1/8/2008, 11:46 am
Re: S&G: uh oh! fill coat trouble??
Renee -- 1/8/2008, 2:33 pm
Thanks!
Mike Scarborough -- 1/8/2008, 2:43 pm
Re: Thanks!
Renee -- 1/8/2008, 3:36 pm
Re: Thanks!
Ross Leidy -- 1/8/2008, 3:45 pm
Re: Thanks!
Renee -- 1/8/2008, 4:15 pm
Re: Thanks! *Pic*
Dave Houser -- 1/9/2008, 12:10 am
Re: Thanks!
Renee -- 1/9/2008, 11:07 pm
Re: Supplies
Mike Scarborough -- 1/11/2008, 9:35 am
Re: Supplies
Dan Caouette (CSFW) -- 1/11/2008, 11:02 am
Re: Scotchbrite and Rollers
vk1nf -- 1/8/2008, 10:05 pm
Re: Thanks!
Ross Leidy -- 1/8/2008, 8:56 pm
Re: Thanks!
Donovan -- 1/8/2008, 11:24 pm
Re: Rollers
Mike Scarborough -- 1/8/2008, 5:22 pm
Re: S&G: uh oh! fill coat trouble??
Renee -- 1/8/2008, 12:03 pm
Re: S&G: uh oh! fill coat trouble?? *LINK*
Glen Smith -- 1/8/2008, 12:11 pm
Re: S&G: uh oh! fill coat trouble??
Renee -- 1/8/2008, 12:17 pm
Re: S&G: uh oh! fill coat trouble??
Glen Smith -- 1/8/2008, 12:25 pm
thanks mike and glen
Renee -- 1/8/2008, 1:22 pm