Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Steaming Plywood
In Response To: S&G: Steaming Plywood (Pozamua)
1/8" Luan or 1/4" ? 1/8" will usually take a deck bend without too much trouble. You could wet the faces both over and under with boiling water and a sponge and that would help quite a bit. Also, in my experience Luan will bend one way better than the other and hopefully you can get the length you need with the best bending grain.
Messages In This Thread
- S&G: Steaming Plywood
Pozamua -- 1/16/2008, 5:48 pm- Re: S&G: Steaming Plywood
Paul G. Jacobson -- 1/18/2008, 7:30 pm- Re: S&G: Steaming Plywood
Acors -- 1/18/2008, 6:10 pm- Heat Bending Plywood *Pic*
mike allen -- 1/18/2008, 12:26 am- Re: S&G: Steaming Plywood
Kudzu -- 1/17/2008, 1:46 pm- Re: S&G: Steaming Plywood
Rob Macks / Laughing Loon CC&K -- 1/17/2008, 10:33 am- Re: S&G: Steaming Plywood
Bill Hamm -- 1/20/2008, 3:32 am- Re: S&G: Steaming Plywood
LeeG -- 1/18/2008, 2:25 pm - Re: S&G: Steaming Plywood
- Steaming Plywood
Jay Babina -- 1/17/2008, 8:46 am- Re: Steaming Plywood
Pozamua -- 1/17/2008, 9:10 am- Re: Steaming Plywood
Bill Hamm -- 1/17/2008, 7:56 pm
- Re: Steaming Plywood
- Re: S&G: Steaming Plywood *Pic*
John Monroe -- 1/17/2008, 4:00 am- Re: S&G: Steaming Plywood
Bill Hamm -- 1/17/2008, 1:45 am- Re: S&G: Steaming Plywood
Charlie -- 1/16/2008, 7:49 pm- Re: S&G: Steaming Plywood
Mike Savage -- 1/16/2008, 7:23 pm - Re: S&G: Steaming Plywood
- Re: S&G: Steaming Plywood
