Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: table saw blades
By:Nick Schade - Guillemot Kayaks
Date: 10/30/2001, 8:54 am
In Response To: table saw blades (mike arnopol)

I've been using a Freud "Diablo" 7 1/4" diameter, 24 tooth blade. They are inexpensive, well made, and thin kerf. Cheap enough that I got two and put spacers between them so I can cut two strips at once.

Messages In This Thread

table saw blades
mike arnopol -- 10/29/2001, 4:54 pm
go 7 1/2"
Jay Babina -- 10/30/2001, 11:06 am
Re: table saw blades
Nick Schade - Guillemot Kayaks -- 10/30/2001, 8:54 am
three blades
David Barrett -- 10/30/2001, 2:57 pm
Re: table saw blades
Jim Kozel -- 10/30/2001, 9:50 am
Re: Blade Spacers
Nick Schade - Guillemot Kayaks -- 10/30/2001, 11:48 am
A new tool idea for any enterprising tool maker
Paul G. Jacobson -- 10/30/2001, 9:04 pm
Re: table saw blades
daren neufeld -- 10/29/2001, 8:59 pm
Re: clamps
bob Kelim -- 10/29/2001, 8:53 pm
Re: clamps
Matthew -- 10/29/2001, 9:21 pm
Re: clamps *NM*
Alice -- 10/29/2001, 9:02 pm
Re: table saw blades
ken -- 10/29/2001, 5:16 pm
Re: table saw blades
jim kozel -- 10/29/2001, 10:31 pm
Re: table saw blades
mike arnopol -- 10/29/2001, 4:56 pm