Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: strip milling progress, then ...
By:Brian Ramoly
Date: 11/7/2001, 12:57 pm
In Response To: Strip: strip milling progress, then ... (Brian Ramoly)

I was rereading my saw's instruction manual. The Delta table saw has a two-year limited warranty. The saw is less than two years old, so I will be getting on the phone with Delta when I log off here. wish me luck.

Brian Ramoly

Messages In This Thread

Strip: strip milling progress, then ...
Brian Ramoly -- 11/6/2001, 3:06 pm
Re: Strip: strip milling progress, then ...
Simon Baillie -- 11/7/2001, 8:36 pm
Re: Strip: strip milling progress, then ...
Brian Ramoly -- 11/7/2001, 12:57 pm
Re: Strip: strip milling progress, then ...
Bob Deutsch -- 11/6/2001, 4:09 pm
Re: Strip: strip milling progress, then ...
Toby Ebens -- 11/6/2001, 6:34 pm
Re: Strip: strip milling progress, then ...
Erich Eppert -- 11/6/2001, 10:59 pm
Re: Tune-up Time Perhaps ??
Rehd -- 11/6/2001, 11:39 pm
Re: Tune-up Time Perhaps ??
Erich Eppert -- 11/8/2001, 10:21 am
Re: Excellent Buy O.T.
Rehd -- 11/8/2001, 4:52 pm
Re: Strip: strip milling progress, then ...
Jerry Siegel -- 11/6/2001, 4:05 pm
Re: Strip: strip milling progress, then ...
Bob Deutsch -- 11/6/2001, 4:11 pm
Re: Strip: strip milling progress, then ...
Jerry Siegel -- 11/6/2001, 4:28 pm