Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: strip milling progress, then ...
By:Simon Baillie
Date: 11/7/2001, 8:36 pm
In Response To: Strip: strip milling progress, then ... (Brian Ramoly)

I spent about 4 hours this weekend ripping strips with an old tablesaw. The saw is at least 20 years old, and still runs very well. It is a belt drive, by Rockwell Beaver. I set it up to rip 3 strips at once, using freud 7 1/4 inch thin kerf 20 tooth blades. The saw doesn't seem to slow down at all when cutting 3/4 inch white cedar boards.

Messages In This Thread

Strip: strip milling progress, then ...
Brian Ramoly -- 11/6/2001, 3:06 pm
Re: Strip: strip milling progress, then ...
Simon Baillie -- 11/7/2001, 8:36 pm
Re: Strip: strip milling progress, then ...
Brian Ramoly -- 11/7/2001, 12:57 pm
Re: Strip: strip milling progress, then ...
Bob Deutsch -- 11/6/2001, 4:09 pm
Re: Strip: strip milling progress, then ...
Toby Ebens -- 11/6/2001, 6:34 pm
Re: Strip: strip milling progress, then ...
Erich Eppert -- 11/6/2001, 10:59 pm
Re: Tune-up Time Perhaps ??
Rehd -- 11/6/2001, 11:39 pm
Re: Tune-up Time Perhaps ??
Erich Eppert -- 11/8/2001, 10:21 am
Re: Excellent Buy O.T.
Rehd -- 11/8/2001, 4:52 pm
Re: Strip: strip milling progress, then ...
Jerry Siegel -- 11/6/2001, 4:05 pm
Re: Strip: strip milling progress, then ...
Bob Deutsch -- 11/6/2001, 4:11 pm
Re: Strip: strip milling progress, then ...
Jerry Siegel -- 11/6/2001, 4:28 pm