: Well I had just finished planing the bottom panels of my boat and was adding
: the angles to the ends (hope you understand this), anyways, I was in quite
: a hurry and a cut them upside-down. So if I continued to build my boat
: like this I would sink into the water. I was hoping to find out if I
: should simply cut off a few inches and correct it or if there is another
: solution I haven't thought of.

Are you cutting the shape of the plywood sections and turned it the wrong way?

Or.... are you merely cutting the bevel on the edges of the panels so that they will fit snuggly together?

Rehd