Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Strip thickness
By:daren neufeld
Date: 11/12/2001, 11:01 pm
In Response To: Strip: Strip thickness (Scott)

check to make sure that your fence is perfectly parrallel to the blade. my saw has a very poor fence and i was getting the same results as you until i trued up the fence by clamping an angle iron behind it to hold it in place.
lots of folks use 3/16 strips to build there boats.
daren.....

Messages In This Thread

Strip: Strip thickness
Scott -- 11/12/2001, 9:02 pm
cut them down to size first.
Paul G. Jacobson -- 11/13/2001, 9:22 pm
Re: Strip: Strip thickness
Scott -- 11/13/2001, 9:07 pm
curved board?
Frank Eberdt -- 11/13/2001, 3:36 pm
Re: Strip: Strip thickness
Chip Sandresky -- 11/13/2001, 3:21 pm
Re: Strip: Strip thickness...Me too..me too
Ben Staley -- 11/13/2001, 3:30 pm
Re: Strip: Strip thickness
Rob Macks -- 11/13/2001, 11:15 am
Cutting Strips (long)
Rob Macks -- 11/13/2001, 11:45 am
Cutting Strips: Final thought
Rob Macks -- 11/13/2001, 12:15 pm
Re: Strip: Strip thickness
Erich Eppert -- 11/13/2001, 10:46 am
Re: Strip: Strip thickness
Nick Schade - Guillemot Kayaks -- 11/13/2001, 10:08 am
Re: Strip: Strip thickness
Kurt -- 11/13/2001, 10:05 am
Re: Strip: Strip thickness
ken -- 11/13/2001, 4:39 pm
Re: Strip: Strip thickness
Malcolm Schweizer -- 11/13/2001, 3:36 pm
Re: Strip: Strip thickness *Pic*
Rick Brannan -- 11/13/2001, 1:33 pm
Re: Strip: Strip thickness
Rob Schaum -- 11/13/2001, 8:22 am
Re: Strip: Strip thickness
ken -- 11/13/2001, 6:44 am
Re: Strip: Strip thickness
Rick M. -- 11/13/2001, 3:31 am
Re: Strip: Strip thickness
Dean Trexel -- 11/12/2001, 11:56 pm
Re: Strip: Strip thickness
daren neufeld -- 11/12/2001, 11:01 pm