Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Strip thickness
By:Nick Schade - Guillemot Kayaks
Date: 11/13/2001, 10:08 am
In Response To: Strip: Strip thickness (Scott)

There is enough extra material with 1/4" strips that you can afford having some of them going a little thin.

Check to see if one edge of your board is curved. If it is concave, it may be hard to force it against the fence. Flip the board over so you are cutting off the convex edge.

Messages In This Thread

Strip: Strip thickness
Scott -- 11/12/2001, 9:02 pm
cut them down to size first.
Paul G. Jacobson -- 11/13/2001, 9:22 pm
Re: Strip: Strip thickness
Scott -- 11/13/2001, 9:07 pm
curved board?
Frank Eberdt -- 11/13/2001, 3:36 pm
Re: Strip: Strip thickness
Chip Sandresky -- 11/13/2001, 3:21 pm
Re: Strip: Strip thickness...Me too..me too
Ben Staley -- 11/13/2001, 3:30 pm
Re: Strip: Strip thickness
Rob Macks -- 11/13/2001, 11:15 am
Cutting Strips (long)
Rob Macks -- 11/13/2001, 11:45 am
Cutting Strips: Final thought
Rob Macks -- 11/13/2001, 12:15 pm
Re: Strip: Strip thickness
Erich Eppert -- 11/13/2001, 10:46 am
Re: Strip: Strip thickness
Nick Schade - Guillemot Kayaks -- 11/13/2001, 10:08 am
Re: Strip: Strip thickness
Kurt -- 11/13/2001, 10:05 am
Re: Strip: Strip thickness
ken -- 11/13/2001, 4:39 pm
Re: Strip: Strip thickness
Malcolm Schweizer -- 11/13/2001, 3:36 pm
Re: Strip: Strip thickness *Pic*
Rick Brannan -- 11/13/2001, 1:33 pm
Re: Strip: Strip thickness
Rob Schaum -- 11/13/2001, 8:22 am
Re: Strip: Strip thickness
ken -- 11/13/2001, 6:44 am
Re: Strip: Strip thickness
Rick M. -- 11/13/2001, 3:31 am
Re: Strip: Strip thickness
Dean Trexel -- 11/12/2001, 11:56 pm
Re: Strip: Strip thickness
daren neufeld -- 11/12/2001, 11:01 pm