Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Reliance Outer Stem
By:Chip Sandresky
Date: 11/18/2001, 10:24 pm
In Response To: Re: Strip: Reliance Outer Stem (Roy Morford)

: Sure it takes a little time with the razor saw and chisel, but the end result
: is going to look so cool.

I hope so. The b**ch was shaping the inner stem. Each strip lands on the inner stem as if it was a mold with faired edges. You're supposed to be able to carve it using a batten as a guide before the stripping begins. I ended up pairing it as I went. It will be cool; I'm glad to have had the experience.

Messages In This Thread

Strip: Reliance Outer Stem *Pic*
Chip Sandresky -- 11/17/2001, 8:21 pm
Re: Strip: Reliance Outer Stem
Scott E. Davis -- 11/19/2001, 1:25 pm
Re: Strip: Reliance Outer Stem
Chip Sandresky -- 11/19/2001, 1:48 pm
Re: Strip: Reliance Outer Stem
Bobby Curtis -- 11/19/2001, 8:09 am
Re: Strip: Reliance Outer Stem *Pic*
Chip Sandresky -- 11/19/2001, 1:07 pm
Re: Strip: Reliance Outer Stem
Scott E. Davis -- 11/19/2001, 1:33 pm
Re: Strip: Reliance Outer Stem
Chip Sandresky -- 11/19/2001, 1:45 pm
Re: Strip: Reliance Outer Stem
Jay Babina -- 11/19/2001, 9:10 am
Re: Strip: Reliance Outer Stem
Roy Morford -- 11/18/2001, 12:36 pm
Re: Strip: Reliance Outer Stem
Chip Sandresky -- 11/18/2001, 10:24 pm