Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: not a problem if
By:Geo. Cushing
Date: 1/6/2002, 8:17 pm
In Response To: not a problem if (Charlie Jones)

: you are using a disc made for use in a table or radial arm saw. I have two
: made by Sears (craftsman) that work very well.
I agree, I think the RA saw turns at over 4000 rpm.
: I make replacement paper discs with floor sander paper and contact cement.
I'm cheap too, but I like 3M's sanding disk cement available at autobody supply stores.

Messages In This Thread

Tools: 12" Disc Sander--My favorite tool. *Pic*
John Monfoe -- 1/3/2002, 8:32 am
My old table saw...
Brian Nystrom -- 1/3/2002, 2:58 pm
Re: My old table saw...
Brad Farr -- 1/4/2002, 10:54 pm
Reduce your speed to 1750 RPM with pulley. *NM*
John Monfoe -- 1/5/2002, 5:40 am
Re: My old table saw...
Myrl Tanton -- 1/4/2002, 4:15 pm
not a problem if
Charlie Jones -- 1/4/2002, 8:32 pm
Re: not a problem if
Geo. Cushing -- 1/6/2002, 8:17 pm
Re: Tools: 12" Disc Sander--My favorite tool.
Brad Farr -- 1/3/2002, 2:36 pm
Re: Tools: 12" Disc Sander--My favorite tool.
Jay Babina -- 1/3/2002, 10:29 am
Re: Tools: 12" Disc Sander--My favorite tool.
Myrl Tanton -- 1/3/2002, 11:34 am
Re: Ditto
Don Beale -- 1/3/2002, 1:37 pm