Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Tools: table saw insert
By:Bob Deutsch
Date: 1/9/2002, 6:51 am
In Response To: Tools: table saw insert (KenC)

Ken...
I also used a Craftsman saw in August to mill my strips for a Silver (and King). I picked up a broken piece of formica at Home Depot (look for the broken pieces in the rack...gives you a discount). I then cut it to fit the top of my table saw..so that the guide cleared it as well...then used hot glue. Then I raised my blade through the formica....and...you have a zero tolerance uniform surfaced top. I also used the featherboard setup suggested by Rob Macks. This was my first time milling strips....also the first time I have used a tablessaw in about 35 years. The setup was great...and safe.
Enjoy....Bob

: Sears tells me they don't make a zero-clearance throat insert for my model of
: Craftsman table saw. Any suggestions on best methods to make one from
: scratch?

: Thanks

Messages In This Thread

Tools: table saw insert
KenC -- 1/8/2002, 8:43 pm
Zero clearance insert? Why bother? *Pic*
Pete Rudie -- 1/13/2002, 12:24 am
Re: Tools: table saw insert
Mark Kanzler -- 1/10/2002, 3:05 pm
Re: Hey buddy, long time no see!
Shawn Baker -- 1/10/2002, 3:12 pm
Re: Hey buddy, long time no see!
Mark Kanzler -- 1/10/2002, 3:37 pm
Re: Hey buddy, long time no see!
Don Beale -- 1/10/2002, 10:13 pm
Re: Park the Deere, have a cuppa on the EFP!
Scotty -- 1/11/2002, 10:25 am
Re: Tools: table saw insert
Brent Curtis -- 1/9/2002, 8:20 pm
Re: Tools: table saw insert
Bob Deutsch -- 1/9/2002, 6:51 am
on my really old Craftsman
Charlie Jones -- 1/9/2002, 12:51 am
Thanks for the suggestions
KenC -- 1/8/2002, 11:18 pm
Re: Tools: table saw insert
Charles Cooper -- 1/8/2002, 11:13 pm
Re: Tools: table saw insert
Tom Johansen -- 1/8/2002, 10:05 pm
Re: Tools: table saw insert
Paul G. Jacobson -- 1/8/2002, 9:34 pm
one more thought
Paul G. Jacobson -- 1/8/2002, 9:37 pm
Re: Tools: table saw insert
Shawn Baker -- 1/8/2002, 9:04 pm
Re: Tools: table saw insert
Larry C. -- 1/8/2002, 8:57 pm