Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Time is of the essence
By:Tom Johansen
Date: 1/11/2002, 12:22 am
In Response To: Re: Time is of the essence (Rob Macks)

: I'd just hot glue the stations in place ( if they're not already in place)
: and wrap it in plastic (see my other posting on this).

: Forget ratchets or only exterior pressure if you're only out of alignment
: 1/2". You can pull that in any time, but if you leave straps on I'd be
: concerned that they'd make dips in the hull after a few months.

: Rob

I also had a move at the same point of construction when I built a double. I put 3 sets of straps on in September (I had a very hard time getting it aligned) and left it like that in storage until I glassed the seams the following May. I had no problems from the straps other than a little dimpling of the epoxy from the cloth. I still had sanding and filling to do so it really was not a problem.

Tom

Messages In This Thread

Strip: Hull Too Wide? *Pic*
Rick Brannan -- 1/9/2002, 11:37 am
Re: Strip: Hull Too Wide?
David Bryson -- 1/10/2002, 5:37 pm
Re: Strip: Hull Too Wide?
Stan Snapp -- 1/12/2002, 11:47 am
Re: Time is of the essence
Shawn Baker -- 1/10/2002, 3:14 pm
Re: Time is of the essence
Rick Brannan -- 1/10/2002, 3:48 pm
Re: Time is of the essence
Rob Macks -- 1/10/2002, 4:39 pm
Re: Time is of the essence
Tom Johansen -- 1/11/2002, 12:22 am
Re: Strip: Hull Too Wide?
John Monfoe -- 1/10/2002, 4:49 am
make it fit like a glove
Tom Johansen -- 1/9/2002, 11:22 pm
Re: Strip: Hull Too Wide?
jim kozel -- 1/9/2002, 4:16 pm
Re: Strip: Hull Too Wide?
Ben Staley -- 1/9/2002, 12:29 pm
Re: Strip: Hull Too Wide?
Rick Brannan -- 1/9/2002, 2:55 pm
Re: Strip: Hull Too Wide?
Paul G. Jacobson -- 1/9/2002, 9:02 pm
Re: Strip: Hull Too Wide?
Craig -- 1/9/2002, 8:05 pm
Re: Strip: Hull Too Wide?
Andreas -- 1/11/2002, 11:48 am
Re: Strip: Hull Too Wide?
Rob Macks -- 1/9/2002, 10:33 pm
Re: Strip: Hull Too Wide?
Rob Macks -- 1/10/2002, 4:33 pm
Re: Strip: Hull Too Wide?
Al Gunther -- 1/11/2002, 12:03 am
Re: Strip: Hull Too Wide?
Charlie Lesh -- 1/9/2002, 12:28 pm