Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Tools: Which Flush Cutting Hand Saw? *Pic*
By:John Schroeder
Date: 1/28/2002, 1:46 pm
In Response To: Re: Tools: Which Flush Cutting Hand Saw? (Shawn Baker)

: Why not drill a small hole in the deck. Align the ABS pipe with this hole,
: and glue the ABS to the inside of the deck. Ream out the deck to match the
: inside of the pipe after the epoxy has cured. Seal the endgrain of the
: wood exposed--now you will have a much less noticeable hole.

So why didn't you suggest this a couple weeks ago before I put my outlet in place ;(

If 'n When II

Messages In This Thread

Tools: Which Flush Cutting Hand Saw?
Jim Owens -- 1/26/2002, 8:27 pm
Re: Tools: Which Flush Cutting Hand Saw?
Shawn Baker -- 1/28/2002, 1:39 pm
Re: Tools: Which Flush Cutting Hand Saw?
Jim Owens -- 1/28/2002, 3:12 pm
Re: Tools: Which Flush Cutting Hand Saw? *Pic*
John Schroeder -- 1/28/2002, 1:46 pm
Re: Sorry John!!!
Shawn Baker -- 1/28/2002, 2:11 pm
Is the outlet in a curved surface?
Brian Nystrom -- 1/28/2002, 1:20 pm
Re: Go with the pull saw
Don Beale -- 1/27/2002, 12:39 pm
Re: Tools: Which Flush Cutting Hand Saw?
Tom Johansen -- 1/26/2002, 9:53 pm