Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: Material: Wire for stitching *Pic*
By:Bobby Curtis
Date: 2/23/2002, 12:43 pm
Date: 2/23/2002, 12:43 pm
In Response To: Material: Wire for stitching (Patsy)
Patsy
I have used 18 gauge Copper Wire for all of my S&G kayaks. I found it available in rolls at my local hardware store It's also available from Chesapeake Light Craft. On average I used lengths of 4 inches. A 1/16 inch hole drilled 5/16 inch from the edge was quite adequate. I spaced my wires at 3-inch intervals.
Bobby
Messages In This Thread
- Material: Wire for stitching
Patsy -- 2/23/2002, 8:38 am- Re: Material: Wire for stitching
Severne -- 2/25/2002, 11:14 am- Re: Material: Wire for stitching
Paul G. Jacobson -- 2/24/2002, 1:42 am- Re: Material: Wire for stitching
David Ross -- 2/23/2002, 5:29 pm- Re: Material: Wire for stitching
Mike Hanks -- 2/23/2002, 10:43 pm
- Re: Material: Wire for stitching *Pic*
Bobby Curtis -- 2/23/2002, 12:43 pm- Re: Material: Wire for stitching
Scott Fitzgerrell -- 2/23/2002, 12:37 pm- Re: Material: Wire for stitching
Rehd -- 2/23/2002, 9:35 am- Re: Material: Wire for stitching
Rehd -- 2/23/2002, 9:39 am
- Re: Material: Wire for stitching
- Re: Material: Wire for stitching
