: Have you tried using a cabinet scraper to scrape off the epoxy ridges? It
: cuts into the wood a lot less than sandpaper does, while still knocking
: off the high spots. There's an article in the current WoodenBoat about
: using scrapers on epoxy coated surfaces.
: Ken

I recently have been a convert to cabinet scrappers to work the fill coats of epoxy. (Thanks to the posts on this site) I suppose it would be equally valued after an initial seal coat.

A word of caution though. You should really sand a little (60 grit?)after using a scraper to get a tooth for the next eposy layer to bond to.

Tom