Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Sawing paddle blades
By:Max Stevens
Date: 3/12/2002, 12:44 pm
In Response To: Re: Strip: Sawing paddle blades (Nick Schade - Guillemot Kayaks)

: However you can use a jig saw to cut each lamination individually
: before gluing them up. This is obviously more work, but the result will be
: the same. You might want to make the pieces a little wider than you would
: if you cut the blank with a bandsaw. This will permit a little inaccuracy
: in the glue up.

Ahh, this sounds like it will work quite well, actually. I'll give this a try.

Thanks everybody for the help!

Max

Messages In This Thread

Strip: Bandsaw vs table saw?
Max Stevens -- 3/11/2002, 12:53 pm
Re: Strip: Bandsaw vs table saw?
Erich Eppert -- 3/12/2002, 1:07 pm
Re: Strip: Bandsaw vs table saw?
John Monfoe -- 3/12/2002, 6:59 am
Re: Strip: Bandsaw vs table saw?
Brian Nystrom -- 3/11/2002, 1:41 pm
Re: Strip: Bandsaw vs table saw?
Scott e. Davis -- 3/11/2002, 1:29 pm
Re: Strip: Bandsaw vs table saw?
Rehd -- 3/11/2002, 1:04 pm
Re: Strip: Bandsaw vs table saw?
Max Stevens -- 3/11/2002, 5:41 pm
Re: Strip: Sawing paddle blades
Nick Schade - Guillemot Kayaks -- 3/12/2002, 9:16 am
Re: Carve Paddles
Rick M -- 3/13/2002, 9:09 pm
Re: Strip: Sawing paddle blades
Max Stevens -- 3/12/2002, 12:44 pm
Re: Paddle Forms ??
Rehd -- 3/12/2002, 2:38 am
Re: Strip: Bandsaw vs table saw?
KenC -- 3/11/2002, 11:52 pm