Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Rough sawn lumber
By:Don Price
Date: 3/12/2002, 5:26 pm
In Response To: Strip: Rough sawn lumber (Brian)

I would cut planks and then cut strips.If possible using the band saw on both operations.You want your strips to end up edge grain.The table saw will also work on cutting the strips whatever blade has the smaller kerf.You want to keep the saw dust pile to a minimum.Good luck

Messages In This Thread

Strip: Rough sawn lumber
Brian -- 3/12/2002, 4:42 pm
Re: Strip: Rough sawn lumber
Rich Paulsen -- 3/14/2002, 12:00 am
Re: Strip: Rough sawn lumber *NM*
Rich Paulsen -- 3/13/2002, 11:52 pm
Re: Strip: Rough sawn lumber
Rob Macks -- 3/13/2002, 9:43 am
Re: Strip: Rough sawn lumber
Scott e. Davis -- 3/13/2002, 1:33 pm
Re: Strip: Rough sawn lumber
Ed Walshe - Dublin -- 3/13/2002, 8:17 am
Re: Strip: Rough sawn lumber
Bobby Curtis -- 3/13/2002, 7:54 am
Re: Strip: Rough sawn lumber *Pic*
Myrl Tanton -- 3/12/2002, 6:07 pm
Re: Strip: Rough sawn lumber
Don Price -- 3/12/2002, 5:26 pm