Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: I think so
By:LeeG
Date: 4/13/2002, 9:20 pm
In Response To: I think so (Pete Roszyk)

I was free handing it with the rotary hole saw, the guide couldn't go to that shallow of a depth but I was able to make a very straight line holding it at an angle against the depth guide, I wonder if a router would have too much horsepower to remove little amounts with control? Hmmm maybe I better go back to Home depot and check out a trimmer as Mathwew mentioned. Just think at this rate I should be making a strip boat in 5yrs.

Messages In This Thread

Tools: tool question
LeeG -- 4/13/2002, 7:16 pm
Re: Tools: tool question
John Monfoe -- 4/14/2002, 6:05 am
Re: Tools: tool question
Terry -- 4/14/2002, 1:27 pm
Re: Tools: tool question *Pic*
John Monfoe -- 4/15/2002, 6:56 am
router guide for straight cuts
c2g -- 4/14/2002, 7:51 am
nuts
c2g -- 4/14/2002, 7:56 am
routing out a strip?
Tom -- 4/14/2002, 7:17 am
Re: Tools: tool question *Pic*
daren neufeld -- 4/13/2002, 10:31 pm
Re: Tools: tool question
Matthew -- 4/13/2002, 7:57 pm
I think so
Pete Roszyk -- 4/13/2002, 7:42 pm
Re: I think so
LeeG -- 4/13/2002, 9:20 pm
Re: I think so
Matthew -- 4/13/2002, 10:42 pm
Re: I think so
Rehd -- 4/13/2002, 9:30 pm