Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: Strip: In lay borders/lines *Pic*
By:John Monfoe
Date: 4/14/2002, 5:47 am
Date: 4/14/2002, 5:47 am
In Response To: Strip: In lay borders/lines (Mike)
I don't know if this will help you but this is the way I will do this. In the picture you will see the inlay border at the top and bottom with a 5/16" walnut strip next to a 1/16" pine strip. I will glue 3/4" wide pine and walnut strips together then run this 1 1/2" wide strip through the table saw to get the walnut and pine widths. It will be much easier to glue the wide strips together then if I tried to glue the small width strips to them selves I think.
John
Messages In This Thread
- Strip: In lay borders/lines
Mike -- 4/13/2002, 11:41 pm- Re: Strip: In lay borders/lines
Chip Sandresky -- 4/14/2002, 4:52 pm- Re: Strip: In lay borders/lines
Mike -- 4/14/2002, 10:52 pm- Veneer Banding? *Pic*
Chip Sandresky -- 4/15/2002, 12:43 pm
- Veneer Banding? *Pic*
- Re: Strip: In lay borders/lines *Pic*
John Monfoe -- 4/14/2002, 5:47 am- Re: Strip: In lay borders/lines
KenC -- 4/14/2002, 3:13 pm- I like you way better then Mine.
John Monfoe -- 4/15/2002, 5:41 am
- I like you way better then Mine.
- Re: Strip: In lay borders/lines
- Re: Strip: In lay borders/lines
