Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: Other: Cutting seat out of f/g yak (Help)
By:Steve Mehder
Date: 5/5/2002, 1:23 pm
Date: 5/5/2002, 1:23 pm
In Response To: Other: Cutting seat out of f/g yak (Help) (David Johnson)
: Help! I have a Nigel Foster Legend. I would like to remove the factory
: seat-but adhesive was used at the factory to bond the front of the seat to
: the hull. How do I remove the factory seat? It does not appear that I can
: get between the seat and the bottom of the hull. I am planning on
: replacing the seat with minicell foam.
: Thanks, David
If you can get some fishing line under the seat, floss it out. You would be suprised how much nylon fishing line will cut adhesive. If it was epoxied, good luck!!!
Messages In This Thread
- Other: Cutting seat out of f/g yak (Help)
David Johnson -- 5/5/2002, 10:51 am- How important is old seat?
Rod Tait -- 5/6/2002, 11:06 am- Re: Other: Cutting seat out of f/g yak (Help)
Mark Kanzler -- 5/5/2002, 11:42 pm- Re: Other: Cutting seat out of f/g yak (Help)
daren neufeld -- 5/5/2002, 2:01 pm- Re: Other: Cutting seat out of f/g yak (Help)
Steve Mehder -- 5/5/2002, 1:23 pm - Re: Other: Cutting seat out of f/g yak (Help)
- How important is old seat?
