Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

3/16" cove & bead / Thanks Rob
By:Jim Kozel
Date: 5/10/2002, 9:52 am
In Response To: Re: Strip: cove & bead on 3/16? (Rob Macks)

: A 3/16" RADIUS = a 3/8" cove & bead.

: A 1/8" RADIUS = a 1/4" cove & bead.

Thanks, Rob -
Read the original post LATE last night and thought, "Cool!" and ordered the 3/16" radius bit online at about 1:45 am. I just called and cancelled. I'll continue using my 1/4" diameter cove/bead bits. You saved me $35. Thanks for pointing out that was the "radius" not "diameter".

Messages In This Thread

Strip: cove & bead on 3/16?
Rob P -- 5/8/2002, 3:21 pm
Re: Strip: cove & bead on 3/16?
David White -- 5/9/2002, 11:29 pm
Re: Strip: cove & bead on 3/16?
Rob Macks -- 5/10/2002, 9:05 am
3/16" cove & bead / Thanks Rob
Jim Kozel -- 5/10/2002, 9:52 am
Re: 3/16" cove & bead / Thanks Rob
Rob Macks -- 5/10/2002, 1:48 pm
Whoops... *NM*
David White -- 5/10/2002, 1:25 pm
Re: Strip: cove & bead on 3/16?
Rob P -- 5/9/2002, 2:00 pm
Re: Strip: cove & bead on 3/16?
Rob Macks -- 5/8/2002, 11:37 pm
Re: Strip: cove & bead on 3/16 - router adjustment
Jim Kozel -- 5/9/2002, 9:48 am
Re: Strip: cove & bead on 3/16 - router adjustment
Rob Macks -- 5/9/2002, 10:54 am
Re: Strip: cove & bead on 3/16?
Scott Fitzgerrell -- 5/8/2002, 10:06 pm
Re: Strip: cove & bead on 3/16?
John Michne -- 5/8/2002, 7:13 pm
Re: Strip: cove & bead on 3/16?
Chip Sandresky -- 5/8/2002, 4:16 pm