Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

and let me add.
By:Paul G. Jacobson
Date: 8/23/2002, 8:28 pm
In Response To: making a table for a circular saw . (Paul G. Jacobson)

If you plan to remove the saw and later re-mount it for ripping more strips, or, if you find the saw wiggles a bit you can add a few scraps of wood under the table. Slide them up next to the base of the saw on three or four sides, roughly framing he saw baswe, and attach with a small amount of glue and screws. Once the glue sets those strips will be permanently attached. They'll make later removal and reinstallation of the saw a snap. Just drop the saw into the outline they form. Your bolts will hold the saw tight to the board, and the frame around the base will keep the saw from moving side-to-side.

PGJ

Messages In This Thread

Tools: table saw and air cleaner recommendations
greg root -- 8/21/2002, 10:48 am
Re: Tools: table saw and air cleaner recommendatio
Jay Babina -- 8/22/2002, 3:41 pm
Re: Tools: table saw and air cleaner recommendatio
greg root -- 8/22/2002, 6:41 pm
Re: Tools: Cheap Table Saw, Home-Made
Rehd -- 8/23/2002, 1:37 am
circ saw as table saw
mike allen -- 8/26/2002, 8:32 pm
Re: circ saw as table saw
Gary -- 1/11/2003, 1:00 pm
Jay, Paul and Rehd-Thanks!
greg root -- 8/23/2002, 8:18 am
making a table for a circular saw .
Paul G. Jacobson -- 8/23/2002, 1:02 am
and let me add.
Paul G. Jacobson -- 8/23/2002, 8:28 pm
Re: and let me add.
jimkozel -- 8/23/2002, 10:59 pm
good point
Paul G. Jacobson -- 8/23/2002, 11:57 pm
local high school/ Community college wood shop
Tony -- 8/21/2002, 4:01 pm
Recent table saw lessons learned
Brian Nystrom -- 8/21/2002, 1:27 pm
Re: Tools: table saw and air cleaner recommendatio
Kurt Loup, Baton Rouge -- 8/21/2002, 12:02 pm
Re: Tools: thanks!
Ross Leidy -- 8/21/2002, 1:18 pm
Re: Tools: thanks!
Kurt Loup, Baton Rouge -- 8/21/2002, 2:09 pm
Re: Bet not!
Don Beale -- 8/22/2002, 12:00 am
Thanks for the link, Don
Brian Nystrom -- 8/22/2002, 1:33 pm