: Warren,
: I'm building the guillemot from the table of offsets in Nick's book. I
: plotted up the forms using Microsoft Visio (used a macro function to place
: dots from 0,0 coordinate). the program shows how each page (11.5x8 inch
: regular sheet) cuts off each form, and I placed a little cross at each
: corner of each page. that way, you can cut them out, and tape them
: together. I tried using excel, but it doesn't print out to scale (i.e. 1
: inch does not equal one inch). I also didn't have the time to learn how to
: do it in CAD.

Very cool! You should offer it up as shareware or freeware. Likely there are other folks who aren't up to speed in CAD, but lack your macro-writing capabilities....

: This was a lot easier than taking a ruler and figuring out what 1.23 inches
: left was on a ruler.

Just under 1 1/4"!!!

Shawn
(CAD user...12 years)