Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Strip width - how wide is too wide?
By:Rick Sylvia
Date: 11/19/2002, 8:16 am
In Response To: Re: Material: Strip width - how wide is too wide? (Jeff The Tall)

I'm sorry - I think I was unclear. These were two different rough cut boards. Each board is consistent, though. I do have a thickness planner, and did run them through it to get a smoother side to make the milling easier (less friction against the infeed/outfeed and table saw surfaces) before cuting the strips. Now that I have the strips, I'm concerned that they are too wide. Sorry for the confusion.

Rick

Messages In This Thread

Material: Strip width - how wide is too wide?
Rick Sylvia -- 11/18/2002, 11:42 am
Re: Material: Strip width - how wide is too wide? *Pic*
Matthew Bowman -- 11/19/2002, 8:02 pm
Re: Material: Strip width - how wide is too wide? *Pic*
Tom Johansnen -- 11/19/2002, 12:47 am
Re: Material: Strip width - how wide is too wide?
Jeff The Tall -- 11/18/2002, 7:06 pm
Re: Material: Strip width - how wide is too wide?
Rick Sylvia -- 11/19/2002, 8:16 am
Re: Material: Strip width - how wide is too wide?
Rick Sylvia -- 11/18/2002, 2:57 pm
Re: Material: Strip width - how wide is too wide?
Paul G. Jacobson -- 11/19/2002, 8:54 pm
Re: Material: Strip width - how wide is too wide?
Brian Ervin -- 11/18/2002, 2:35 pm
Re: Material: Strip width - how wide is too wide?
Kent LeBoutillier -- 11/18/2002, 11:59 am