Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Light weight layup *Pic*
By:Chip Sandresky
Date: 12/5/2002, 7:25 pm
In Response To: Re: Material: Light weight layup (Mark)

Welcome Mark, glad to have you aboard. There is a good deal of interest in vacuum bagging here; not that many people have tried it. I'm tempted to bag my next hull but I'm not sure how to handle the point where the glass meets the mastic. Right, figure I'm doing the outside of the hull (like the picture below). I have a 3/4" lip around the opening (bottom) and there are molds inside the boat. Do I put the mastic along the lip? How do I keep the glass from interfering with the seal - trim it close, let it hang in a pleat? I guess I'd trim it proud of the edge (say, 1" back from the sheer line) and then cover that area later when I glass the deck on.

We have a big RC airplane club in Redmond WA. I was down at the airfield with my kids Sunday and one guy had a homebuilt plane that must have had a 10ft wingspan on it... three props. It had a radio controlled trap door; the pilot hit a button and a dozen little parachutes dropped out :D I wish I had had my camera. Any plans to build a kayak?

- Chip
http://www.nwlink.com/~chips

Messages In This Thread

Material: Light weight layup
Larry C. -- 12/5/2002, 12:30 pm
I'm building one too
Jack Sanderson -- 12/6/2002, 2:49 pm
Re: I'm building one too
Larry C. -- 12/7/2002, 8:17 am
Thanks, everyone *NM*
Larry C. -- 12/7/2002, 8:22 am
Re: Material: Light weight layup
Paul G. Jacobson -- 12/6/2002, 1:08 am
Re: Material: Light weight layup
Jeff The Tall -- 12/6/2002, 3:18 pm
Re: Material: Light weight layup
Mike Loriz -- 12/6/2002, 1:11 pm
Re: Material: Light weight layup
Don Lucas -- 12/6/2002, 11:04 am
Re: Material: Light weight layup - Bulkheads
KenB -- 12/6/2002, 1:02 pm
Re: Material: Light weight layup - Bulkheads
Shawn Baker -- 12/6/2002, 4:44 pm
Re: Material: Light weight layup
Mark -- 12/5/2002, 6:53 pm
Re: Material: Light weight layup
Mike Loriz -- 12/6/2002, 12:57 pm
Re: Material: Light weight layup *Pic*
Chip Sandresky -- 12/5/2002, 7:25 pm
Budget, weaker pressure "vacuum bagging"
Paul G. Jacobson -- 12/6/2002, 10:42 pm
Re: vac bagging
Mark -- 12/6/2002, 10:15 am
Re: vac bagging
Jeff The Tall -- 12/6/2002, 2:48 pm
Re: vac bagging
Shawn Baker -- 12/6/2002, 6:16 pm
Re: vac bagging
Chip Sandresky -- 12/6/2002, 5:25 pm
Re: vac bagging
Mark -- 12/7/2002, 12:58 pm
Re: vac bagging *LINK*
david schneider -- 12/14/2002, 12:03 pm
Re: vac bagging
Roger Nuffer -- 12/14/2002, 12:58 pm
Re: vac bagging *LINK*
david schneider -- 12/14/2002, 4:25 pm
Re: vac bagging
Shawn Baker -- 12/6/2002, 6:20 pm
Re: vac bagging
Mark -- 12/6/2002, 4:52 pm
Re: vac bagging
Jeff The Tall -- 12/9/2002, 4:52 pm
Re: vac bagging - OK for Wiki?
Shawn Baker -- 12/6/2002, 6:19 pm
OT: thanks for the pic
Larry -- 12/5/2002, 10:50 pm
Re: Material: Light weight layup
Scott Fitzgerrell -- 12/5/2002, 3:18 pm
Re: Material: Light weight layup
Rob Macks -- 12/5/2002, 4:03 pm
Re: Material: Light weight layup
Shawn Baker -- 12/5/2002, 4:25 pm
Re: Material: Light weight layup
Mike Loriz -- 12/5/2002, 2:37 pm
Re: Material: Light weight layup
Jim Kozel -- 12/5/2002, 3:11 pm
Re: Material: Light weight layup
mike loriz -- 12/5/2002, 5:09 pm
Re: Material: Light weight layup
Jim Kozel -- 12/7/2002, 9:41 am
Re: Material: Light weight layup
Mike Loriz -- 12/10/2002, 7:33 pm
Re: Material: Light weight layup
Fred -- 12/7/2002, 10:08 am
Re: Material: Light weight layup
Jim Kozel -- 12/7/2002, 11:32 am
Re: Material: Light weight layup
KenB -- 12/5/2002, 2:29 pm
Re: Material: Light weight layup
LeeG -- 12/6/2002, 2:28 pm
Re: Material: Light weight layup
Chip Sandresky -- 12/5/2002, 3:12 pm
Re: Material: Light weight layup
Shawn Baker -- 12/5/2002, 2:24 pm
Out there.
Myrl Tanton -- 12/5/2002, 12:44 pm
Re: Out there.
Ross Sieber -- 12/5/2002, 1:49 pm
RE: Boom! - are you sure?
Myrl Tanton -- 12/5/2002, 3:50 pm
Re: RE: Boom! - are you sure?
Larry -- 12/5/2002, 10:34 pm
Re: Float bag contents
Shawn Baker -- 12/5/2002, 4:23 pm
Re: COTFLGUOAHAHA
Ross Sieber -- 12/5/2002, 5:13 pm
Re: RE: Boom! - are you sure? *LINK*
Ross Sieber -- 12/5/2002, 4:23 pm
Re: Out there.
Don Flowers -- 12/5/2002, 3:15 pm
Re: Boom!
Shawn Baker -- 12/5/2002, 2:17 pm
Re: Out there.
Bruce -- 12/5/2002, 1:18 pm