Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Tools: Sharpening
By:Rick Allnutt
Date: 12/10/2002, 8:16 am
In Response To: Re: Tools: Sharpening (Rehd)

Rehd,

I like the idea but don't quite get the picture. Here you have a blade held in correct angle to the surface of the glass/sandpaper. There you have a holder which you use to stroke the surface of the blade on the sandpaper. You do not use a circular motion, so you must use a linear motion, back and forth I presume. Is that motion as though the blade is cutting into the paper or is it 90 degrees to that direction? Does the blade holder also rub on the sandpaper, or is it on the glass next to the paper?

And, OBTW, if you have a picture of your little holder it would help me too. I enjoy the wheels you have already invented.

Desperate in Ohio,
as I am in the middle of planing a Guillemot.

Rick

Messages In This Thread

Tools: wood planes
Ron Jenkins -- 12/7/2002, 8:08 pm
Re: Tools: wood planes
Brian Nystrom -- 12/9/2002, 3:02 pm
Re: Tools: wood planes
Rob P -- 12/10/2002, 10:31 am
Re: Tools: wood planes *Pic*
Chip Sandresky -- 12/8/2002, 7:31 pm
Re: Tools: wood planes
Randy Oswald -- 12/9/2002, 5:09 pm
Re: Tools: wood planes
Mike Scarborough -- 12/8/2002, 8:28 am
Re: Tools: wood planes *LINK*
Kurt Loup, Baton Rouge -- 12/7/2002, 10:45 pm
Re: Tools: Sharpening
Chris -- 12/7/2002, 11:09 pm
Re: Tools: Sharpening
Chip Sandresky -- 12/11/2002, 2:07 pm
Link to Scary Sharp *LINK*
Rick Allnutt -- 12/10/2002, 8:43 am
One Scary Sharp caveat
Brian Nystrom -- 12/10/2002, 1:04 pm
Re: Tools: Sharpening
Jay Babina -- 12/9/2002, 9:06 am
Re: Tools: Sharpening
Rehd -- 12/9/2002, 9:40 pm
Re: Tools: Sharpening
Rick Allnutt -- 12/10/2002, 8:16 am
Re: Tools: More on Sharpening
Rehd -- 12/10/2002, 4:14 pm
Re: My Set Up... Cheap, but Affective *Pic*
Rehd -- 12/12/2002, 1:41 pm
Re: My Set Up... Cheap, but Affective
Ken Sutherland -- 12/13/2002, 12:53 am
Re: Special Delivery
Rehd -- 12/13/2002, 2:57 am
Jigs *Pic*
Bill Price -- 12/11/2002, 12:46 pm
Thanks Rehd! Great post! *NM*
Rick Allnutt -- 12/11/2002, 8:01 am
Re: Tools: Scary-Sharp
KenC -- 12/9/2002, 11:32 pm