Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: My Set Up... Cheap, but Affective *Pic*
By:Rehd
Date: 12/12/2002, 1:41 pm
In Response To: Re: Tools: More on Sharpening (Rehd)

Here's the method I use, taken from the "Scary-Sharp" article.

A friend that lurks here saw my post and came over with her camera. She took them, scanned them and sent them back. Thanks Margie!!

I guess I only have 8 pcs of Sil/Carb. paper there. ?? Anyway, there's the cheap guide and paper glued to the glass. I use the water to spray the paper, one sheet at a time, then do each one until I get the desired affect and then move on. Works like a champ and only takes a few seconds on each grit to get that mirror-like finish and razor edge.

When I'm done, I just set it off to the side or in a closet until needed again.

Rehd

p.s. Back to baking...

Messages In This Thread

Tools: wood planes
Ron Jenkins -- 12/7/2002, 8:08 pm
Re: Tools: wood planes
Brian Nystrom -- 12/9/2002, 3:02 pm
Re: Tools: wood planes
Rob P -- 12/10/2002, 10:31 am
Re: Tools: wood planes *Pic*
Chip Sandresky -- 12/8/2002, 7:31 pm
Re: Tools: wood planes
Randy Oswald -- 12/9/2002, 5:09 pm
Re: Tools: wood planes
Mike Scarborough -- 12/8/2002, 8:28 am
Re: Tools: wood planes *LINK*
Kurt Loup, Baton Rouge -- 12/7/2002, 10:45 pm
Re: Tools: Sharpening
Chris -- 12/7/2002, 11:09 pm
Re: Tools: Sharpening
Chip Sandresky -- 12/11/2002, 2:07 pm
Link to Scary Sharp *LINK*
Rick Allnutt -- 12/10/2002, 8:43 am
One Scary Sharp caveat
Brian Nystrom -- 12/10/2002, 1:04 pm
Re: Tools: Sharpening
Jay Babina -- 12/9/2002, 9:06 am
Re: Tools: Sharpening
Rehd -- 12/9/2002, 9:40 pm
Re: Tools: Sharpening
Rick Allnutt -- 12/10/2002, 8:16 am
Re: Tools: More on Sharpening
Rehd -- 12/10/2002, 4:14 pm
Re: My Set Up... Cheap, but Affective *Pic*
Rehd -- 12/12/2002, 1:41 pm
Re: My Set Up... Cheap, but Affective
Ken Sutherland -- 12/13/2002, 12:53 am
Re: Special Delivery
Rehd -- 12/13/2002, 2:57 am
Jigs *Pic*
Bill Price -- 12/11/2002, 12:46 pm
Thanks Rehd! Great post! *NM*
Rick Allnutt -- 12/11/2002, 8:01 am
Re: Tools: Scary-Sharp
KenC -- 12/9/2002, 11:32 pm