Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: Strip: Zero Clearance Fence?
By:Jack Sanderson
Date: 12/17/2002, 2:54 pm
Date: 12/17/2002, 2:54 pm
In Response To: Re: Strip: routing bead and coves - centering *Pic* (Chip Sandresky)
Chip & Others,
What is the collective feeling on zero clearence fences. I noticed chip had an arch opening the full size of the bit on his router table fence.
Is it necessary or desirable to make a zero clearance insert to get better beads and/or coves.
Regards,
Jack
Messages In This Thread
- Strip: routing bead and coves - centering
Gordon Snapp -- 12/17/2002, 12:26 am- Re: Router Setup
KenB -- 12/17/2002, 1:38 pm- Don't bottom out your bits
Mark Rakestraw in upstate NY -- 12/18/2002, 1:21 pm- Re: Don't bottom out your bits *LINK*
Steve Frederick -- 12/18/2002, 7:19 pm- Re: Don't bottom out your bits
Mark Rakestraw in upstate NY -- 12/18/2002, 8:18 pm
- Re: Don't bottom out your bits
- Re: Don't bottom out your bits *LINK*
- Re: Strip: routing bead and coves - centering *Pic*
Chip Sandresky -- 12/17/2002, 1:29 pm- Re: Strip: Zero Clearance Fence?
Jack Sanderson -- 12/17/2002, 2:54 pm- Re: Strip: Zero Clearance Fence?
Chip Sandresky -- 12/17/2002, 4:14 pm- Re: Strip: Zero Clearance Fence?
Ross Sieber -- 12/17/2002, 3:15 pm - Re: Strip: Zero Clearance Fence?
- Re: Strip: Zero Clearance Fence?
- Re: Strip: routing bead and coves - centering
Jay Babina -- 12/17/2002, 11:58 am- Re: Strip: routing bead and coves - centering *LINK* *Pic*
Kurt Loup, Baton Rouge -- 12/17/2002, 9:10 am- Re: Strip: Exactly!! Easy!!
Rehd -- 12/17/2002, 3:39 am - Don't bottom out your bits
- Re: Router Setup
