Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Zero Clearance Fence?
By:Chip Sandresky
Date: 12/17/2002, 4:14 pm
In Response To: Re: Strip: Zero Clearance Fence? (Jack Sanderson)

: Is it necessary or desirable to make a zero clearance insert to get better
: beads and/or coves.

Hey why not; the more control you have on the leading edge of that cutter the better. I guess you'd want zero clearance (or close to it) side to side and room for adjustment top to bottom. Customization is a good thing IMCO :D My next router project will hopefully be on a brand new machine. I sent that table home with the guy I borrowed the router from... hope I never see it again.

Messages In This Thread

Strip: routing bead and coves - centering
Gordon Snapp -- 12/17/2002, 12:26 am
Re: Router Setup
KenB -- 12/17/2002, 1:38 pm
Don't bottom out your bits
Mark Rakestraw in upstate NY -- 12/18/2002, 1:21 pm
Re: Don't bottom out your bits *LINK*
Steve Frederick -- 12/18/2002, 7:19 pm
Re: Don't bottom out your bits
Mark Rakestraw in upstate NY -- 12/18/2002, 8:18 pm
Re: Strip: routing bead and coves - centering *Pic*
Chip Sandresky -- 12/17/2002, 1:29 pm
Re: Strip: Zero Clearance Fence?
Jack Sanderson -- 12/17/2002, 2:54 pm
Re: Strip: Zero Clearance Fence?
Chip Sandresky -- 12/17/2002, 4:14 pm
Re: Strip: Zero Clearance Fence?
Ross Sieber -- 12/17/2002, 3:15 pm
Re: Strip: routing bead and coves - centering
Jay Babina -- 12/17/2002, 11:58 am
Re: Strip: routing bead and coves - centering *LINK* *Pic*
Kurt Loup, Baton Rouge -- 12/17/2002, 9:10 am
Re: Strip: Exactly!! Easy!!
Rehd -- 12/17/2002, 3:39 am