Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

sorry - I was refering to a stripper
By:Jay Babina
Date: 1/1/2003, 10:20 am
In Response To: Re: Material: Sanpaper by the Ton? (Jay Babina)

Pretty much the same except you don't have to sand the insides. If your epoxy work is good there's very little sanding. If you get runs and drips, you have to scrape them then sand a bit.

Messages In This Thread

Material: Sanpaper by the Ton? *LINK*
Kurt Maurer -- 12/31/2002, 6:15 pm
Re: Material: Sanpaper by the Ton? *LINK*
Randy Oswald -- 1/6/2003, 11:21 am
Re: Material: Sanpaper by the Ton?
Jay Babina -- 1/1/2003, 10:13 am
sorry - I was refering to a stripper
Jay Babina -- 1/1/2003, 10:20 am
Re: sorry - I was refering to a stripper *LINK*
Kurt Maurer -- 1/1/2003, 12:31 pm
Re: sorry - I was refering to a stripper
Jay Babina -- 1/2/2003, 10:28 am
To Blush, or not to Blush... *LINK*
Kurt Maurer -- 1/2/2003, 11:00 am
it doesn't hurt to just wash the boat.
Paul G. Jacobson -- 1/2/2003, 7:29 pm
Scrapers for epoxy
Peter Robinson in Oz -- 1/1/2003, 5:41 pm
Re: scrapers
Mike Hanks -- 1/1/2003, 3:05 pm
Re: scrapers *LINK*
Kurt Maurer -- 1/1/2003, 4:57 pm
Re: scrapers
Mike Hanks -- 1/2/2003, 10:30 am
Re: scrapers *LINK*
Kurt Maurer -- 1/2/2003, 1:50 pm
Re: scrapers
Rehd -- 1/1/2003, 5:48 pm
Re: scrapers
Peter Robinson in Oz -- 1/1/2003, 5:45 pm
sanding
Peter Lyons -- 1/1/2003, 12:43 pm
Re: sanding *LINK*
Kurt Maurer -- 1/1/2003, 4:05 pm