Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: sorry - I was refering to a stripper *LINK*
By:Kurt Maurer
Date: 1/1/2003, 12:31 pm
In Response To: sorry - I was refering to a stripper (Jay Babina)

: Pretty much the same except you don't have to sand the insides. If your epoxy
: work is good there's very little sanding. If you get runs and drips, you
: have to scrape them then sand a bit.

Jay

Appreciate the feedback. I have heard that epoxy gunks up sandpaper almost instantly, and so was preparing to toss a pad every coupla minutes.

Any comments regarding scrapers... that is, what to use and where to get? I like scrapers, and this is the first reference to them I have heard regarding epoxy finishing.

Cheers,
Kurt Maurer
Galveston Bay, Texas

Pair O' Mill Creeks Project

Messages In This Thread

Material: Sanpaper by the Ton? *LINK*
Kurt Maurer -- 12/31/2002, 6:15 pm
Re: Material: Sanpaper by the Ton? *LINK*
Randy Oswald -- 1/6/2003, 11:21 am
Re: Material: Sanpaper by the Ton?
Jay Babina -- 1/1/2003, 10:13 am
sorry - I was refering to a stripper
Jay Babina -- 1/1/2003, 10:20 am
Re: sorry - I was refering to a stripper *LINK*
Kurt Maurer -- 1/1/2003, 12:31 pm
Re: sorry - I was refering to a stripper
Jay Babina -- 1/2/2003, 10:28 am
To Blush, or not to Blush... *LINK*
Kurt Maurer -- 1/2/2003, 11:00 am
it doesn't hurt to just wash the boat.
Paul G. Jacobson -- 1/2/2003, 7:29 pm
Scrapers for epoxy
Peter Robinson in Oz -- 1/1/2003, 5:41 pm
Re: scrapers
Mike Hanks -- 1/1/2003, 3:05 pm
Re: scrapers *LINK*
Kurt Maurer -- 1/1/2003, 4:57 pm
Re: scrapers
Mike Hanks -- 1/2/2003, 10:30 am
Re: scrapers *LINK*
Kurt Maurer -- 1/2/2003, 1:50 pm
Re: scrapers
Rehd -- 1/1/2003, 5:48 pm
Re: scrapers
Peter Robinson in Oz -- 1/1/2003, 5:45 pm
sanding
Peter Lyons -- 1/1/2003, 12:43 pm
Re: sanding *LINK*
Kurt Maurer -- 1/1/2003, 4:05 pm