Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Tools: which router bit?
By:Nick Schade - Guillemot Kayaks
Date: 1/21/2003, 11:27 am
In Response To: Tools: which router bit? (Al)

: Hi...
: I am building a merganser hybrid kit, my first experience with striping. It
: is my understanding that I need to remove the cove on the "starter
: strips", not knowing much about router bits.....does anyone know
: which bit I should purchase to remove the cove? The strips are standard
: 3/16 x 6'. Thanks.... Al

You can use a hand plane or table saw to square up one edge of a strip.

Messages In This Thread

Tools: which router bit?
Al -- 1/21/2003, 10:38 am
Re: Tools: which router bit?
Larry C. -- 1/21/2003, 9:23 pm
Re: Tools: which router bit?
Ed Roberts -- 1/21/2003, 11:19 pm
Re: Tools: which router bit?
Nick Schade - Guillemot Kayaks -- 1/21/2003, 11:27 am
Re: Tools: which router bit?
Al -- 1/21/2003, 12:10 pm
Re: Tools: which router bit? *LINK*
Steve Frederick -- 1/21/2003, 8:20 pm
Re: Tools: which router bit?
Nick Schade - Guillemot Kayaks -- 1/21/2003, 2:25 pm
Re: Tools: which router bit?
Jim Kozel -- 1/21/2003, 1:45 pm