Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Epoxy: Mixing more batches in same container
By:Wade
Date: 4/2/2003, 7:59 am

I'm getting to the point where I'll be laying up the fiberglass fairly soon. Everything I've seen recommends mixing up only 2 or 3 ounces of epoxy at one time.

When mixing up small batches of expoxy, do you need to go to a clean container when mixing a new batch? Does the unhardened epoxy left over from the previous mix cause an acceleration of the gelling of the new mix?

Wade

Messages In This Thread

Epoxy: Mixing more batches in same container
Wade -- 4/2/2003, 7:59 am
Re: Epoxy: Mixing more batches in same container
rnb4tla -- 4/2/2003, 9:20 pm
I Wouldn't Risk It
Ken -- 4/2/2003, 3:57 pm
Re: Epoxy: Mixing more batches in same container
Chip Sandresky -- 4/2/2003, 12:30 pm
Re: Epoxy: Mixing more batches in same container
Malcolm Schweizer -- 4/2/2003, 9:55 am
Re: Epoxy: Mixing more batches in same container
Jay Thomas -- 4/2/2003, 10:49 am
"Burping" pumps
Randy Oswald -- 4/2/2003, 12:49 pm
Re: "Burping" pumps
Rob Macks -- 4/4/2003, 12:05 pm
Re: "Burping" pumps
Shawn Baker -- 4/3/2003, 5:44 pm
Re: "Burping" pumps
Jay Babina -- 4/4/2003, 1:45 pm
Re: "Burping" pumps
Randy Oswald -- 4/4/2003, 11:28 am
Re: "Burping" pumps
Mark Normand -- 4/3/2003, 8:45 am
Re: "Burping" pumps
Randy Oswald -- 4/3/2003, 3:27 pm
Re: Epoxy: Mixing more batches in same container
Shawn Baker -- 4/2/2003, 9:54 am