Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Perhaps a good precaution would be...
By:Brian Nystrom
Date: 4/11/2003, 3:07 pm
In Response To: Re: Strip: Using heat to assist deck hull alignmen (Wes Tanaka)

...to epoxy the struts to the hatch covers before cutting them out. You could start cuts on each side to help locate the struts, then finish the cuts after the struts are glued in place.

Messages In This Thread

Strip: Using heat to assist deck hull alignment
Andy Loudon -- 4/10/2003, 9:14 pm
Re: Strip: Using heat to assist deck hull alignmen
Ken -- 4/11/2003, 7:10 am
Re: Strip: Fixing deck hull mis-alignment
Rob Macks -- 4/11/2003, 8:41 am
Re: Strip: Fixing deck hull mis-alignment
Andy Loudon -- 4/11/2003, 11:02 pm
Re: Strip: Using heat to assist deck hull alignmen
Greg Hughes -- 4/11/2003, 6:31 am
Re: Strip: Using heat to assist deck hull alignmen
Wes Tanaka -- 4/10/2003, 9:53 pm
Perhaps a good precaution would be...
Brian Nystrom -- 4/11/2003, 3:08 pm
Perhaps a good precaution would be...
Brian Nystrom -- 4/11/2003, 3:07 pm