Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Epoxy: Wetting out the glass
By:Bobby Curtis
Date: 6/2/2003, 10:41 pm
In Response To: Re: Epoxy: Wetting out the glass (Joe Voutour)

Joe

I don't thin epoxy. If I want it to flow on easier, I raise the room temperature to 80 degrees and above. To apply a thin coat, I use a small amount on foam brush and then squeegee off the excess.

Bobby

Messages In This Thread

Epoxy: Wetting out the glass
Joe Voutour -- 5/30/2003, 10:58 pm
Re: Epoxy: Wetting out the glass
jack krause -- 5/31/2003, 8:25 pm
Re: Epoxy: Wetting out the glass
Joe Voutour -- 6/2/2003, 6:59 pm
Re: Epoxy: Wetting out the glass
jack krause -- 6/2/2003, 7:27 pm
Re: Epoxy: Wetting out the glass
Rob Macks -- 5/31/2003, 10:29 am
Re: Epoxy: Wetting out the glass
Joe Voutour -- 6/2/2003, 7:03 pm
Re: Epoxy: Wetting out the glass
Bobby Curtis -- 5/31/2003, 6:48 am
Re: Epoxy: Wetting out the glass
Joe Voutour -- 6/2/2003, 7:05 pm
Re: Epoxy: Wetting out the glass
Bobby Curtis -- 6/2/2003, 10:41 pm