Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: S&G: Overlapping Fiberglass.
By:Jeff The Tall
Date: 6/16/2003, 4:22 pm
Date: 6/16/2003, 4:22 pm
In Response To: S&G: Overlapping Fiberglass. (Mark Reaves)
It will dissapear pretty well, you may never be able to tell which side you had to patch.
however. DO NOT SAND GREEN EPOXY. It will smear rather than sand, and all fo the "dust" will be embedded in the epoxy. You can either use a scraper to feather this out while it is green. Or you can just do 3 or so fill coats, allow to harden, then feather with a sander and recoat with one layer of epoxy where needed.
Messages In This Thread
- S&G: Overlapping Fiberglass.
Mark Reaves -- 6/16/2003, 11:59 am- A point about feathering
Paul G. Jacobson -- 6/16/2003, 11:46 pm- Re: S&G: Overlapping Fiberglass.
Bill Burton -- 6/16/2003, 5:48 pm- Re: S&G: Overlapping Fiberglass.
srchr/gerald -- 6/16/2003, 4:45 pm- Re: S&G: Overlapping Fiberglass.
Jeff The Tall -- 6/16/2003, 4:22 pm- Re: S&G: Overlapping Fiberglass. *LINK*
Dave -- 6/16/2003, 3:31 pm- Re: S&G: Overlapping Fiberglass.
Dave Sprygada -- 6/16/2003, 1:37 pm - Re: S&G: Overlapping Fiberglass.
- A point about feathering
