Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: don't rebreathe from balloons.
By:Chip Sandresky
Date: 6/17/2003, 12:16 am
In Response To: don't rebreathe from balloons. (Paul G. Jacobson)

: If you want to test your lung capacity, breathe into plastic bags, not
: balloons. The common balloons are coated with a fine powder,

Good point. I just used a grocery bag to test it out. My lungs started to tell me when the oxygen content was too low - which I expected. I started to feel a little dizzy too which I didn't expect. I don't know if I would want to play that game in the water.

Messages In This Thread

Other: need help: air supply from within the hull *LINK*
Erez -- 6/16/2003, 5:32 pm
Re: Other: need help: air supply from within the h
Jay Babina -- 6/17/2003, 9:45 am
Re: Other: need help: air supply from within the h
Jay Babina -- 6/17/2003, 9:33 am
Sea Kayaker had an article on this
Dan G -- 6/17/2003, 8:25 am
mouthpieces -- not the lawyer type :)
Paul G. Jacobson -- 6/17/2003, 11:18 pm
Need oxygen dummies!!
Pete Notman -- 6/17/2003, 5:58 am
Fart Tubes!!
Myrl Tanton -- 6/17/2003, 12:11 am
Flexable backband
Don -- 6/16/2003, 10:04 pm
partial guess
mike allen -- 6/16/2003, 7:22 pm
more or less to this
Paul G. Jacobson -- 6/16/2003, 10:42 pm
Re: more or less to this
mike allen -- 6/17/2003, 4:12 pm
Re: more or less to this
Paul G. Jacobson -- 6/17/2003, 9:34 pm
even more to this *Pic*
Paul G. Jacobson -- 6/17/2003, 11:13 pm
Re: Other: need help: air supply from within the h
Chip Sandresky -- 6/16/2003, 6:36 pm
Re: Other: need help: air supply from within the h
Wes Tanaka -- 6/16/2003, 11:33 pm
don't rebreathe from balloons.
Paul G. Jacobson -- 6/16/2003, 10:51 pm
Re: don't rebreathe from balloons.
Chip Sandresky -- 6/17/2003, 12:16 am
Re: don't rebreathe from balloons.
topher -- 6/17/2003, 3:25 pm
Re: Other: need help: air supply from within the h
Shawn Baker -- 6/16/2003, 7:14 pm
Re: Other: need help: air supply from within the h
Chip Sandresky -- 6/16/2003, 7:21 pm