Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Completed CF Rudder
By:mike allen
Date: 6/19/2003, 3:17 pm
In Response To: Re: Completed CF Rudder (mike allen)

: a waxed spacer 1/8" wider than the rudder but with a corner
: cut out to hold multiple small lyrs of glass plus the pivot: then the

even w/ flexibility, would probably be a bitch to get out tho', unless it was sacrifical foam or interlocked wedge shaped. also could do one side, other released, then bolts. too bad, a little complex.

Messages In This Thread

Epoxy: Building a CF Rudder *Pic*
Jack Sanderson -- 6/18/2003, 10:24 pm
Completed CF Rudder *Pic*
Jack Sanderson -- 6/19/2003, 8:41 am
Excellent, I built my the same way!
Mike and Rikki -- 6/20/2003, 1:10 am
Re: Completed CF Rudder
Shawn Baker -- 6/19/2003, 3:11 pm
Re: Completed CF Rudder
Jack Sanderson -- 6/19/2003, 10:11 pm
Re: Completed CF Rudder
Sam McFadden -- 6/20/2003, 11:00 am
Re: Completed CF Rudder
Danny -- 6/20/2003, 11:35 am
Try this for an easier release
Mike and Rikki -- 6/20/2003, 1:18 am
Re: Completed CF Rudder
mike allen -- 6/19/2003, 2:34 pm
Re: Completed CF Rudder
Jack Sanderson -- 6/19/2003, 10:03 pm
Re: Completed CF Rudder
mike allen -- 6/19/2003, 3:17 pm
Re: Completed CF Rudder
Chip Sandresky -- 6/19/2003, 1:20 pm
Re: Completed CF Rudder
Jack Sanderson -- 6/19/2003, 9:58 pm
Re: Epoxy: Building a CF Rudder *Pic*
Jack Sanderson -- 6/18/2003, 10:36 pm
Re: Epoxy: Building a CF Rudder *Pic*
Jack Sanderson -- 6/18/2003, 10:32 pm
Re: Epoxy: Building a CF Rudder
Jack Sanderson -- 6/19/2003, 8:53 am