Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Tools: Spokeshave angle?
By:Lennie Hawkins
Date: 6/23/2003, 10:41 am

I’m planing the ends of the boat preparing it for the stem pieces. I’m finding my spokeshave difficult to use. I sharpened it at the same angle as my block plane I think it is at 30 degrees. Is this angle correct for the spokeshave?
I knew I should have taken wood shop!

Thanks,

Lennie

Messages In This Thread

Tools: Spokeshave angle?
Lennie Hawkins -- 6/23/2003, 10:41 am
Re: Tools: Spokeshave angle? *LINK*
Bill Klein -- 6/24/2003, 7:37 am
Have you seen the article?
Brian Nystrom -- 6/24/2003, 1:09 pm
Re: Have you seen the article?
Aaron Cunningham -- 6/24/2003, 1:26 pm
Re: Have you seen the article?
Chip Sandresky -- 6/24/2003, 6:37 pm
Re: Have you seen the article?
Shawn Baker -- 6/24/2003, 4:20 pm
Re: Have you seen the article?
Kurt Loup, Baton Rouge -- 6/24/2003, 4:46 pm
Re: Have you seen the article?
Brian Nystrom -- 6/24/2003, 2:18 pm
Re: Spokeshave angle? Thanks everyone :)
Lennie Hawkins -- 6/24/2003, 10:45 am
Re: Tools: Spokeshave angle?
C. Fronzek -- 6/23/2003, 11:41 pm
Re: Tools: Spokeshave angle?
Brian Nystrom -- 6/23/2003, 1:21 pm
Re: Tools: Spokeshave angle?
Chip Sandresky -- 6/23/2003, 12:45 pm
Re: Tools: Spokeshave angle?
Kurt Loup, Baton Rouge -- 6/23/2003, 12:16 pm
Re: Tools: Spokeshave angle?
Dan Ruff -- 6/23/2003, 12:14 pm
Re: Tools: Spokeshave angle?
Lennie Hawkins -- 6/24/2003, 10:39 am