Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Square edged strips
By:srchr/gerald
Date: 7/3/2003, 1:52 am
In Response To: Strip: Square edged strips (Glen Longino)

I use square edge strips. I've always used square edge strips so I can't compare them with the bead and cove. I'm happy with the square edge strips. I plane them to fit along both edges (rolling bevel) and get tight joints. The joints on the inside are not as tight...but still pretty tight. Someday I probably will build a strip built using the bead and cove strips just to see if it works about like I think it will. Other than that I have no intention of using bead and cove unless I'm building a boat for someone who flat out specifies it

Messages In This Thread

Strip: Square edged strips
Glen Longino -- 7/2/2003, 10:54 pm
Re: Strip: Square edged strips
Glen Longino -- 7/3/2003, 4:33 pm
Re: Strip: Square edged strips
srchr/gerald -- 7/3/2003, 5:08 pm
Re: Strip: Square edged strips
Glen Longino -- 7/3/2003, 6:18 pm
Re: Strip: Square edged strips
srchr/gerald -- 7/3/2003, 7:25 pm
Re: Strip: Square edged strips
Glen Longino -- 7/3/2003, 11:24 pm
Re: Strip: Square edged strips
rnb4tla -- 7/3/2003, 2:13 pm
Re: Strip: Square edged strips *LINK* *Pic*
John Schroeder -- 7/3/2003, 1:44 pm
Re: Strip: Square edged strips
Chip Sandresky -- 7/3/2003, 12:52 pm
Re: Strip: Square edged strips
Jay Babina -- 7/3/2003, 8:22 am
Re: Strip: Square edged strips
Andy -- 7/3/2003, 8:28 am
Re: Strip: Square edged strips
Nick Schade - Guillemot Kayaks -- 7/3/2003, 10:48 am
Thanks Jay and Nick *NM*
Andy -- 7/5/2003, 6:45 am
Re: Strip: Square edged strips
Jay Babina -- 7/3/2003, 10:37 am
I'll never go back
Kent LeBoutillier -- 7/3/2003, 6:03 am
Re: Strip: Square edged strips
srchr/gerald -- 7/3/2003, 1:52 am
Re: Strip: Square edged strips
Paul G. Jacobson -- 7/3/2003, 12:17 am
Re: Strip: Square edged strips *LINK*
Ron Deane -- 7/2/2003, 11:39 pm
Re: Strip: Square edged strips
Dave McKinney -- 7/3/2003, 4:06 pm